Beryl stock SPF

Discussion in 'Part & Accessory Classifieds' started by pogi, Jun 18, 2011.

Thread Status:
Not open for further replies.
  1. pogi

    pogi
    Gresham, OR
    Active Member

    Messages:
    735
    Likes Received:
    97
    SPF
     
    Last edited: Jun 21, 2011
  2. cooper

    cooper
    molalla
    Bronze Supporter Bronze Supporter

    Messages:
    1,038
    Likes Received:
    448
    I thirst for the knowledge, do these ( Beryl ) stocks fit AK type rifles? If so stamped or milled and is part of receiver or screw to tang. Thanks for info, these are fantastic looking folders with a much kinder cheek-weld than typical wire side-folder. Happy Fathers day everybody.
     
  3. pogi

    pogi
    Gresham, OR
    Active Member

    Messages:
    735
    Likes Received:
    97
    The Beryl stock works on a block like the Romanian side folders. All you need is a rear trunnion with a tang on a stamped receiver. The block secures with two screws. It is a very easy set up for a stamped receiver but I'm not sure about a milled receiver.
     
Thread Status:
Not open for further replies.

Share This Page