Member 5605
- Messages
- 11,671
- Reactions
- 23,700
Looking to change some end caps and muzzle devices for quicker on and off of the can on different rifles.
I have 3 rifles threaded in 5/8x24 that I'd put a brake on for can swapping. When I can make it happen, I'll end up with another brake in 5/8x24 and one more in 1/2x28.
My can's internal threads are 1-7/16x20.
I'm lost in all of the terminology ANQ's, JPR's and FDW's etc. it's all Greek to me.
Simply put....
5/8x24 -> (unknown adapter) -> (unknown endcap) -> Suppressor.
I'd prefer to try and limit each muzzle device 'around' $50-70. I'd like to avoid the spring tension design, ratcheting is preferred but I may be hunting a unicorn on that one.
Any assistance?
My two Rimfire cans use the same inside threads but I'm not buying 10 adapters for my Rimfire devices.. just the .30 cals
I have 3 rifles threaded in 5/8x24 that I'd put a brake on for can swapping. When I can make it happen, I'll end up with another brake in 5/8x24 and one more in 1/2x28.
My can's internal threads are 1-7/16x20.
I'm lost in all of the terminology ANQ's, JPR's and FDW's etc. it's all Greek to me.
Simply put....
5/8x24 -> (unknown adapter) -> (unknown endcap) -> Suppressor.
I'd prefer to try and limit each muzzle device 'around' $50-70. I'd like to avoid the spring tension design, ratcheting is preferred but I may be hunting a unicorn on that one.
Any assistance?
My two Rimfire cans use the same inside threads but I'm not buying 10 adapters for my Rimfire devices.. just the .30 cals