Ar lower

OP
2
Messages
1,142
Reactions
300
You could buy an 80% finished lower and finish it yourself.......................... No marks at all!
Yeah, I thought about that and have looked into what it takes to get it done but I just don't have the time right now. Seems like it would be easier to try to find one without.

If I were to get one with minimal markings do you guys know if it's legal to weld up the manufactures name? I would think as long as the serial numbers are still there it would be ok?
 
Messages
5,081
Reactions
7,083
You are getting into a very tricky area. Before obscuring any factory markings on a receiver, I would request a letter from the BATFE clarifying what the laws are. It is my understanding that the manufacturer name and serial number have to remain on the gun.
 

UPCOMING EVENTS

Cerberus Training Group - Skill Builder - Pistol/Rifle Combo
Cerberus Training Group
47 Cattle Dr, Goldendale, WA 98620, USA
Albany Rifle & Pistol Club (ARPC) Gun Show
Linn County Expo Center
3700 Knox Butte Rd E, Albany, OR 97322, USA
Cerberus Training Group - Skill Builder - Pistol/Rifle Combo
Cerberus Training Group
47 Cattle Dr, Goldendale, WA 98620, USA
Arms Collectors of SW Washington Gun Show
Battleground Community Center
912 E Main St, Battle Ground, WA 98604, USA

LATEST RESOURCE REVIEWS

  • J&B Firearm Sales
    5.00 star(s)
    Good local shop
    Picked up a rifle yesterday from J&B. This was the second or third gun purchase over the last few years from them. I always enjoy stopping by...
  • H&K Gun Shop
    5.00 star(s)
    The only place I have found 9mm in stock
    I’ll admit I didn’t even know this place existed, as I don’t tend to go into Forest Grove often. But it’s a giant (looks bigger from the...
  • Revelation Arms
    4.00 star(s)
    Depends who answers the phone
    I was given the number to Roger Loock by Beaver Creek Armory, as I needed parts I had ordered from MCarbo installed on a Kel-Tec Sub2000. On my...
  • Coastal Farm & Ranch - Cornelius
    3.00 star(s)
    Lesson learned
    I’ll take some responsibility here, as I took the employee at their word instead of doing a thorough inspection. Short story is that I asked for a...
  • MK Tactical
    5.00 star(s)
    Good guys!
    I stop in here every once in a while to see what Michael has in the clearance section, and to ask questions when I have a project in mind...
Top Bottom