Bronze Supporter
- Messages
- 1,915
- Reactions
- 1,462
I think it is time to clean up the work bench
Tapco short vertical forward grip, odg with rubber plug for storage.
Two .750" gas blocks, no roll pins, steel one is used cold blued.
B5 systems coyote brown grip with screw.
This is the best grip angle that I have found.
A2 grip, two sets of handguards one has a custom stippling job , almost full gallon tub of clean range brass, 223/556.
New package of anti tilt followers.
Triangle handguard cap.
Front sling mount for a2 with pin.
Carbine length gas tube, used
$40
First one with $50 cash or trades that I can do...gets tw1-1/2 twenty round boxes of 223....(30 rds)
PM me
Thanks for looking
POWDER SOLD!
Trades possible are:
AR rear sight
17 hmr ammo
30 caliber projectiles
9mm defense loads
A1680 powder
H4227 powder
Small rifle Magnum primers
Tapco short vertical forward grip, odg with rubber plug for storage.
Two .750" gas blocks, no roll pins, steel one is used cold blued.
B5 systems coyote brown grip with screw.
This is the best grip angle that I have found.
A2 grip, two sets of handguards one has a custom stippling job , almost full gallon tub of clean range brass, 223/556.
New package of anti tilt followers.
Triangle handguard cap.
Front sling mount for a2 with pin.
Carbine length gas tube, used
$40
First one with $50 cash or trades that I can do...gets tw1-1/2 twenty round boxes of 223....(30 rds)
PM me
Thanks for looking
POWDER SOLD!
Trades possible are:
AR rear sight
17 hmr ammo
30 caliber projectiles
9mm defense loads
A1680 powder
H4227 powder
Small rifle Magnum primers
Last Edited: