Anyone have tooling to barrel a FAL?

Discussion in 'Maintenance & Gunsmithing' started by eganx, Apr 4, 2012.

  1. eganx

    eganx
    Kingston WA
    Active Member

    Messages:
    501
    Likes Received:
    187
    I'm thinking about pulling the barrel back off my FAL and shortening it. I built the gun while living in Louisiana and borrowed a friends tooling to barrel the receiver.......and now he's 2600 miles away. Anyone have a barrel vise, receiver wrench, and the alignment dowels for a FAL?
     
  2. fxdc

    fxdc
    Da Valley
    USPSA, SPEED STEEL, IDPA, 3 GUN

    Messages:
    1,670
    Likes Received:
    1,756
    Ratus on falfiles sells da vise and wrench

    Let me know how ur project wrks out.
     
  3. eganx

    eganx
    Kingston WA
    Active Member

    Messages:
    501
    Likes Received:
    187
    I never ended up doing it....just been busy. However I do have a co-worker who has all the FAL tooling. We are both machinists too......oh the fun we can have
     
  4. Silver Fox

    Silver Fox
    Puyallup, WA
    Well-Known Member

    Messages:
    2,187
    Likes Received:
    300
    I've shortened a FAL barrel on the lathe and didn't have to take the barrel off.

    SF-
     
  5. eganx

    eganx
    Kingston WA
    Active Member

    Messages:
    501
    Likes Received:
    187
    Did you put the receiver in a 4 jaw and the barrel in a steady rest?

    Could you describe your set up?
     

Share This Page