AK Gunsmith near PDX?

Messages
982
Reactions
1,465
Looking for a gunsmith, experienced in drilling and tapping a Draco pistol trunnion. Just need to get someone lined up, so when my form 1 returns (sometime in the next month) I can get it done and put it back together. Planning on installing an ace folder. Thanks,,,:cool:
 
Messages
1,097
Reactions
90
There's a G-Smith that's in Ridgefield Wa. that i'm sure can do that he has done a great job on whatever i bring him.
He is located not to far from the Clark County Fair Grounds. That's not to far from PDX!
JBeagle Rifles 360-727-3248
 

UPCOMING EVENTS

Cerberus Training Group - Skill Builder - Pistol/Rifle Combo
Cerberus Training Group
47 Cattle Dr, Goldendale, WA 98620, USA
Albany Rifle & Pistol Club (ARPC) Gun Show
Linn County Expo Center
3700 Knox Butte Rd E, Albany, OR 97322, USA
Cerberus Training Group - Skill Builder - Pistol/Rifle Combo
Cerberus Training Group
47 Cattle Dr, Goldendale, WA 98620, USA
Arms Collectors of SW Washington Gun Show
Battleground Community Center
912 E Main St, Battle Ground, WA 98604, USA

LATEST RESOURCE REVIEWS

  • J&B Firearm Sales
    5.00 star(s)
    Good local shop
    Picked up a rifle yesterday from J&B. This was the second or third gun purchase over the last few years from them. I always enjoy stopping by...
  • H&K Gun Shop
    5.00 star(s)
    The only place I have found 9mm in stock
    I’ll admit I didn’t even know this place existed, as I don’t tend to go into Forest Grove often. But it’s a giant (looks bigger from the...
  • Revelation Arms
    4.00 star(s)
    Depends who answers the phone
    I was given the number to Roger Loock by Beaver Creek Armory, as I needed parts I had ordered from MCarbo installed on a Kel-Tec Sub2000. On my...
  • Coastal Farm & Ranch - Cornelius
    3.00 star(s)
    Lesson learned
    I’ll take some responsibility here, as I took the employee at their word instead of doing a thorough inspection. Short story is that I asked for a...
  • MK Tactical
    5.00 star(s)
    Good guys!
    I stop in here every once in a while to see what Michael has in the clearance section, and to ask questions when I have a project in mind...
Top Bottom