- Messages
- 194
- Reactions
- 109
Cero forge 80%lower receiver with safety selector trigger and hammer pin holes drilled _**you will need to finish milling out the trigger pocket ( I do not have a jig )
Cero forge t marked upper receiver with forward assist and dust cover installed
Lower parts kit with fire control group , enhanced trigger guard,moe magpul grip
5.56 16"BHW barrel 1/9 twist chrome moly ,m4 profile,yhm flash hider and crush washer
Thunder tech low profile gas block and gas tube
Magpul moe stock, 6 position tube ,buffer and spring ,castle nut,Ambidextrous single point sling end plate
Ambidextrous safety selector
Extended utg charging handle
Low profile flip up sights
Only parts you need to finish is a bolt carrier group and handguard and to mill out the trigger pocket
$375 will not split up sell all or nothing only trade glock 43
Cero forge t marked upper receiver with forward assist and dust cover installed
Lower parts kit with fire control group , enhanced trigger guard,moe magpul grip
5.56 16"BHW barrel 1/9 twist chrome moly ,m4 profile,yhm flash hider and crush washer
Thunder tech low profile gas block and gas tube
Magpul moe stock, 6 position tube ,buffer and spring ,castle nut,Ambidextrous single point sling end plate
Ambidextrous safety selector
Extended utg charging handle
Low profile flip up sights
Only parts you need to finish is a bolt carrier group and handguard and to mill out the trigger pocket
$375 will not split up sell all or nothing only trade glock 43
Last Edited: