Gold Supporter
- Messages
- 24,463
- Reactions
- 37,077
In my quest to find alternative case options for 44-40 cases, I was looking at the 410 hull. The rim on the 410 hull is a little wider and thinner than the 44-40 case but I cut a fresh hull down to 44-40 length and it does chamber up until the brass wall of the hull begins. The brass on the hull is a little wider in diameter but I think it could be sized down in the
44-40 sizing die.
Has anybody tried loading shot loads for their 44-40? If so what kind of patterns did you get?
44-40 sizing die.
Has anybody tried loading shot loads for their 44-40? If so what kind of patterns did you get?