.357 cylinder reamer/chamfer tool

Discussion in 'Parts & Accessories Wanted' started by Ben B., May 14, 2010.

  1. Ben B.

    Ben B.
    Eugene
    Member

    Messages:
    111
    Likes Received:
    3
    I am looking to buy, rent or borrow a reamer to chamfer my .38/.357 cylinder. It needs to be sufficiently sharp to do the job and not worn out or dull-edged.

    I don't mind putting down a deposit for the value. I shoot IPSC/IDPA and steel matches at Eugene, Albany, & sometimes Dundee or TCGC. I would like to hit the occasional ICORE at ARPC. Could meet there and talk if you shoot comps.

    Email or PM. Thanks,

    Ben Bock
    Eugene, OR
     

Share This Page