300AAC Blackout Brass

[Page.k]

So has any one here tried to make 300AAC brass from 223/56 brass? A few places sell the brass or will convert it for you. So any ideas for a jig to speed up the making of 300AAC brass.
A drill press makes a little too much of a mess for my liking.

Read More

 

[AMProducts]

I havn't made any conversion brass yet, have too many irons in the fire to spend time having fun.

However, harbor freight sells these little cheap chop saws for $25 that have a high speed steel blade.

Bench Top Cut Off Saw

I'll make you a jig for holding the brass like I told you I would.

 

[umrek]

3D Printed 300 Blackout Cutoff Chute

I made a chute for the Harbor Freight cutoff saw and brass jig that I use to make 300blk. The 223 necks and most of the brass 'glitter' gets vacuumed up. The cut brass drops into a bucket (not in pic) on the floor next to my bench. No more stopping to clear out a pile of brass and its much...

www.northwestfirearms.com

I make two versions now of you are interested, 1 that pairs with the Zep cutoff jigs for $30 and one that includes an integrated 3D printed cutoff for $40.

Harbor Freight saw not included!

 

[arrowshooter]

This! Version 2 is truly all in one.

 

[Twodogs]

I looked at the cost and time to make 300blk brass and just bought 2000 rds of 300 blk brass and never looked back.