¾ x 10 Thread Adapter?

[CountryGent]

I am looking a Mac-type pistol that the barrel is threaded to ¾ x 10. Does anyone make an adapter to convert said to ½ x 28 or M13.5x1 LH?

I see a number of vendors that sell various conversions, but I haven't found that one yet. Thanks much.

Read More

 

[DirectDrive]

Google USmachinegun

 

[CountryGent]

Google USmachinegun

Thanks. I was on their site earlier in the day and didn't see one under adapters that does what I'm after.

 

[jbett98]

Give Tornado Technologies in Hillsboro a call. He could probably make you one.

(503) 690-8000 (10am - 5pm. Pacific Time, Tues - Friday)

 

[CountryGent]

Thanks @jbett98. I'll reach out to them. A couple years back, I've had a custom one made from Saxonville Armory, so I might contact them too, though I was going to see if there was an "off the shelf" one out there.

Thanks again.

 

[jbett98]

I've got an open bolt Mac 11 and the Bowers suppressor that came with it has that same pitch and you can't get through a 30 rd mag without the can loosening up to the point of wobbling.

US Machinegun will thread your existing barrel down to the size you want for only $95.00 plus shipping.

 

[saxon]

Thanks. I was on their site earlier in the day and didn't see one under adapters that does what I'm after.

email them what you want I am Shure they will have it if not listed