I googled pin and weld to see what folks were doing. I only assumed…. Not hard but still.
I considered and option for brazing or high heat silver solder. Since I use it in my trade often. It can be undone with heat….. but threaded parts will never be the same. I guess the amount of heat needed to braze wouldn't be ideal for the barrel…. Let alone if you have an aluminum device.
So how do the inspect these….. just look for a little bead on top? Or does someone wrench on these to be sure? X-rays?
Wouldn't modern epoxy do the trick? I couldn't be the first person to ponder a faux pin and weld. Not that I would do that….. have never had the need. Just conversation purposes.
I considered and option for brazing or high heat silver solder. Since I use it in my trade often. It can be undone with heat….. but threaded parts will never be the same. I guess the amount of heat needed to braze wouldn't be ideal for the barrel…. Let alone if you have an aluminum device.
So how do the inspect these….. just look for a little bead on top? Or does someone wrench on these to be sure? X-rays?
Wouldn't modern epoxy do the trick? I couldn't be the first person to ponder a faux pin and weld. Not that I would do that….. have never had the need. Just conversation purposes.