Thread: Smith and Wesson #10 re-assembly help needed

I installed a reduced power spring+mainspring and for the life of me I couldn't get it back together with the bobby pin looking safety thing. I put it together without it and it seems to work fine, is it OK?
And the yoke seems to swing out a little stiff is that normal?

Originally Posted by taylor

I installed a reduced power spring+mainspring and for the life of me I couldn't get it back together with the bobby pin looking safety thing. I put it together without it and it seems to work fine, is it OK?
And the yoke seems to swing out a little stiff is that normal?

Another good reason to have a good gunsmith in your back pocket.

I assume you are talking about the hammer block, instead of placing it into the frame and trying to install the sideplate, place it in it's slot in the side plate and keep it there with a bit of grease, then install the sideplate.

If the yolk is stiffer than before you likely over tightened the front plate tension screw, try backing off the front plate screw a little.

Originally Posted by taylor

I installed a reduced power spring+mainspring and for the life of me I couldn't get it back together with the bobby pin looking safety thing. I put it together without it and it seems to work fine, is it OK?
And the yoke seems to swing out a little stiff is that normal?

If you are referring to the hammer block (as mentioned by coop), it is NOT okay.